Allflex AFX-100 Manual do Utilizador descarregar pdf (Página 51)

Rev Australasia V2.3 12/04

51 51

3.2.13. Re-Send Last Tag

In case port type is set to RS232 the reader re-sends last tag read according to the

currently selected ID-Code format settings. In serial bus mode, where port type is set

to either RS422 or RS485, the reader transmits the first read result stored in the ID

code buffer out the serial port, according to the currently selected ID-Code format

settings

. This way the readers can be polled to request tag data from the readers

connected to the bus, as the readers using serial bus mode then do not automatically

send tag data upon successful detection.

Command: r

Parameters: none

Readers Response - No Tag Available:

wo/Command Prompt

w/Command Prompt

*E00<CR><LF>

*E00<CR><LF>

<LF>

3.2.14. Retrieve ID-Code Buffer

Retrieves the entire ID-Code buffer.

Command: G

Parameters: none

Readers Response – Tag Available:

The Reader transmits the entire ID-Code memory according to the current serial ID-

Code format settings

. If the command prompt is enabled, the readers response is

trailed by:

<LF>

Readers Response - No Tag Available:

wo/Command Prompt

w/Command Prompt

*E00<CR><LF>

*E00<CR><LF>

<LF>

3.2.15. Clear ID-Code Memory

Deletes the entire ID-Code memory.

See section 3.2.5. Serial ID-Code format settings.

Error Message: Command couldn't be executed!

See section 3.2.5. Serial ID-Code format settings.

Error Message: Command couldn't be executed!

1 2 ... 46 47 48 49 50 51 52 53

Sem comentários

Allflex AFX-100 Manual do Utilizador Página 51