Allflex AFX-100 Manual do Utilizador descarregar pdf (Página 14)

Rev Australasia V2.3 12/04

14 14

data capture process either into scale heads, or the computer that you are using. In most

cases the software has a means of coping with this.

(b) Electrical Machinery - Most 240 volt AC operated electrical machinery will not interfere

with the Panel Reader’s electrical signals. However, machinery that is electrically

controlled by electronic methods, such as motor speed controls, light dimmers, and solid

state relays can produce high frequency emissions that can cause interference. When the

Panel Reader is being trial installed, the user should run all the machinery in the vicinity

to ensure that all potentially interfering sources do not exist. When wiring an AC mains

operated power supply for use with the Panel Reader, avoid wiring the AC connection to

the same phase as such electric machinery is wired.

- If the Panel Reader is being installed in a location where eartagged

animals will exist on all sides of the Reader (such as a feeder), precautions must be taken

to ensure that only animals within the designated reading zone are read. This can usually

be achieved by positioning sheet metal, or mesh in an appropriate location between the

reader and the area where you want to “block” reading. If you do have multiple eartags

simultaneously present in the read zone of the antenna, either eartag might read, both

eartags might read, or neither eartag might be read.

(d) Other Readers - Operating multiple Panel Readers within close proximity, or operating a

mobile hand-held reader nearby a Panel Reader, can reduce the read range of all readers

present. In some cases this can totally inhibit reading of all readers. If multiple readers are

to be used in proximity to each other, it will be necessary to synchronize the readers.

Synchronization will require additional hardware equipment. Please call Allflex for

assistance with synchronization. Allflex Australia – 07 3245 9100. Allflex New Zealand -

06 356-7199.

Once a suitable location site and installation method have been determined, the Panel Reader

can be permanently mounted in position using the ¼” (6mm) pre-drilled mounting holes. If it

is necessary, alternate or additional mounting holes may be drilled by the user, using caution

to drill only within the rectangle defined by the existing mounting holes. Standard steel bolts

will not compromise Panel Reader performance.

Note - The Panel Reader is designed to be completely water-tight. While not intended for

installation immersed in water, contact with water spray, such as heavy rain or power washers

is acceptable.

Caution! - Ensure that the mounting structure itself is sufficiently strong enough to endure

impact by animals that will come into contact with it. Do not rely on the Panel Reader to

contribute to the structural strength of the installation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 52 53

Sem comentários

Allflex AFX-100 Manual do Utilizador Página 14